Your patina can take anywhere from a few minutes to a couple of days. Important: Set the closed container where curious pets and children can’t access it. Put the lid tightly on your plastic container: Now place the ammonia-soaked paper towels back over the bracelet, so they have contact with the entire outside surface of your bracelet: Then lift up the paper towels and sprinkle a light layer of salt on top of the ammonia-dampened bracelet. Pour ammonia over these paper towels to soak them. Ideally these towels should be covering the entire outside surface of your bracelet. Wad up another paper towel or two, and place them on top of the bracelet. Sprinkle a generous amount of salt over the ammonia-soaked towels, and then set your bracelet on top of them: In the bottom of your plastic grocery container, place a couple of wadded-up paper towels, and then pour ammonia over them till the towels are saturated: Wash off all traces of baking soda – and then without letting your skin touch the newly cleaned metal, dry it thoroughly with paper towels. Scrub in the same direction as the grain of your metal. So before beginning the patina process, wash both sides of your metal bracelet thoroughly with a generous amount of liquid dish soap.Īfter washing off all of the dish soap, sprinkle a small amount of baking soda onto both sides of your bracelet and scrub it well with your steel wool. We need to clean your metal to remove all traces of skin oils and anything else that may resist the patina. Krylon also has a product that’s pretty much the same thing, and about the same price. Sealant – I use a clear, matte-finish, spray-on sealant called “Tree House Studio” Clear Acrylic Matte Coating, from Hobby Lobby.#0000 steel wool – one or two small pieces.
0 Comments
Leave a Reply. |